Are you searching the internet for “Dowel Joint Advantages and Disadvantages“? If so, this guide should help to understand joining wood with dowels. Here we list all of the advantages and disadvantages of dowel jointery.
Table Of Contents:
Use the links below to guide you to the section you are interested in.
Dowel Joint Advantages
- Dowling is a quick process.
- It helps to ensure a neat finish.
- There is no need for screws, nails or other equipment.
- Dowel joints are the strongest type of joints when it comes to woodworking, especially when using multiple rows of dowels.
- Dowels help to create strong joints that are easy to make at home.
Dowel Joints happen to be a technique that is used in woodworking, where two wood pieces are attached by a dowel or wooden pin. In the wood pieces, a hole will be carved where the dowel goes. This is a way to attach wood pieces that you should think about the next time you are woodworking for the bottom reasons.
There’s No Need For Hardware
Dowel joints help to remove the need for screws, staples and nails. This helps to remove the potential injuries that often happen while working with hardware, but it can also help to give the project a more finished look as there is nothing to disrupt the grain pattern.
It Is Secure
The pin runs inside of the wood, so the joint is quite strong, and that is a lot stronger than using glue or nails to attach the wood.
Easy To Assemble
Once you have decided on how big the dowel needs to be, you have to hollow out the holes that the pin goes in. Just slide the pin in the piece of wood and then attach the other piece and that is it. It is that simple.
The dowel joints are basically used in a right angle or flat angle joint because it can be made to work in more complex joints. The dowel joints can also be used in concrete construction and metal work.
Dowel Joint Disadvantages
- Tenon and mortise joints are stronger, but it takes a lot longer to create
- The alignment could be hard to get for beginners as it requires the use of a dowelling.
Disadvantages Posted by Customers
The main disadvantage is that they are weak. When it comes to tenon and mortise joints, the face grain cheeks of the tenon are completely in contact with the face grain side of the mortise. The glue also holds best in this situation. When it comes to dowel joints, there isn’t any face to face grain contact which causes the joint to be weaker.
When making a doweling joint, if the bit slips even just a little when starting the hole, or it isn’t lined up just right, you will have a lot of issues getting the joint aligned and/or getting the dowel in.
Besides the strength of the dowel joint, it is hard to get it aligned right, especially if there isn’t access to a drill press.
Dowels will eventually shear. Then you have to drill it out and then insert a new dowel. The higher quality dowels used the longer the drawers will last.